DIMM 8GB DDR4 2666MHz Kingston HyperX Fury Black CL15 HX426C15FB/8

8GB 1G x 64-Bit DDR4-2666 CL15 288-Pin DIMM

FEATURES
1G x 64-bit (8GB) DDR4-2666 CL15 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components per module. Each module kit supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. Total kit capacity is 32GB. Each module has been tested to run at DDR4-2666 at a low latency timing
of 15-17-17 at 1.2V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below.
The JEDEC standard electrical and mechanical specifications
are as follows:
CL(IDD) - 15 cycles
Row Cycle Time (tRCmin) - 45ns(min.)
Refresh to Active/Refresh - 260ns(min.)
Command Time (tRFCmin) - 26.25ns(min.)

JEDEC/XMP TIMING PARAMETERS
• JEDEC/PnP: DDR4-2666 CL15-17-17 @1.2V
DDR4-2400 CL14-16-16 @1.2V
DDR4-2133 CL12-14-14 @1.2V
•XMP Profile #1: DDR4-2666 CL15-17-17 @1.2V
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Dual-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address